Fast idle?

Anything and everything to do with ascMcLaren cars can go here.
Post Reply
mark@ddi
Posts: 75
Joined: Fri Apr 13, 2007 4:37 pm
Location: missouri
Contact:

Fast idle?

Post by mark@ddi »

Being kind of a newbie at this I run the risk of bringing up topics that are in the arrhives?

My 85 Capri Vert has a fast idle situation. It runs about 1000-1100rpm at stop lights and before I shut it down. No dieseling it shuts tight.

Some times at idle it kinda blump blumps a bit. it could be a fuel thing as it is a bear to start but then I am used to and spoiled by not setting a choke prior to start.

Did I read somewhere that some of the cars shipped to ASC had a 303 Cam? And that since they were mixed in with the entire shipment you really weren't sure if you got one with this cam or not? (I have no paperwork to refer to)

Funny story sorta. I drove the car to work yesterday. Out of the shop and one of the fix it things was to take the driver's side front window trim piece and readhere to the car. This was done with some black adhesive tubular stuff. Pretty sticky. Twice at about 60mph and after 20 minutes or so the wind gets under the trim piece and the thing pops up off the windshield.

I finally pull over go to a parking lot and look at it. You make that decision then and there to go practical vs cosmetic and I take a piece of the adhesive and lay it so that I can push the front trim in the middle of it. Took my finger and smoothed it out to create a wind barrier and then drove home without it coming up again.

My car is a 5' footer and it doesn't show and at least I don't have to fool with it anymore....maybe......sorta??
User avatar
negusm
Site Admin
Posts: 5105
Joined: Wed Aug 25, 2004 6:11 pm
Location: Charlotte, NC
Contact:

Post by negusm »

Verts didn't get the b303.

What is your car, CFI or carbed (automatic or manual transmission)?

Head over to www.foureyedpride.com as there are a fair number of guys with experience with CFI and more with carbs.

-Mike
1985 ascMcLaren Coupe - Midnight Blue
Under Restoration
User avatar
dahberg
Posts: 306
Joined: Sun Aug 29, 2004 5:51 pm
Contact:

Post by dahberg »

Highly likely a vaccum leak. Might be a problem with EUC. As Mike suggests a visit to FEP would be advisable. There are some great people over there with tons of knowledge.
mark@ddi
Posts: 75
Joined: Fri Apr 13, 2007 4:37 pm
Location: missouri
Contact:

Fast idle

Post by mark@ddi »

Thanks!

Will go and browse around the site and see what I can learn.
Post Reply