Q's regarding ASC McLaren side molding and tonnaeu

ASCMCLRN · Post by **ASCMCLRN** » Mon Jun 05, 2006 8:27 pm

My car is still in the shop. I had some rust spots start to surface by the tonnaeu cover on the quarter pannels bothsides and wanted it fixed before it got worse. Well after that was fixed the tonnaeu was really looking weathered so I had that repainted as well. The bodyman said there was like a strip of film extending 2inches around were the top would rest over when up. Does anyone know what this is? I hope I am explaining this correctly.

Next question the side molding on the McLarens is that the same as all other Mustangs or was that changed as well? Thanks.

Nick

Sandy · Post by **Sandy** » Mon Jun 05, 2006 8:57 pm

Moulding is stock Mustang, however, as you know, painted to match the car.

Regarding the clear plastic strip, it's purpose is/was to prevent discoloring of the car's paint, as the wet convertible top's edge rests on the tonneau cover. Yoiu can get NOS fron Hank

http://www.ascmclaren.com

ASCMCLRN · Post by **ASCMCLRN** » Tue Jun 06, 2006 2:11 am

Sandy wrote:Moulding is stock Mustang, however, as you know, painted to match the car.

Regarding the clear plastic strip, it's purpose is/was to prevent discoloring of the car's paint, as the wet convertible top's edge rests on the tonneau cover. Yoiu can get NOS fron Hank

http://www.ascmclaren.com

I called and emailed him before I posted this. I will try to call him again tomorrow. I couldnt find this particular part on his website. Thanks for acknowledging its existance the guy doing the bodywork wasnt sure if it was factory done or aftermarket.

Nick